|
Making a bodybar is not
very difficult, providing that you have access to a saw. PVC pipe
comes in a variety of widths, but they are usually 8-10 feet in
length. I suggest starting with 2" pipe, but you can judge for
yourself when you go to the hardware store based upon the feel of the
pipe.
Things you'll need
-
hack saw or alternative
that can be used to cut the pipe
-
PVC Glue
-
length of PVC pipe
typically 1.5" to 2" for starters
-
2 PVC end caps (same
width as the pipe)
-
Filler: play sand,
pea gravel, rebar, or any combination of stuff to add the weight.
-
plastic funnel (optional
but recommended to get the filler into the pipe)
Using a saw, you cut the
pipe to the desired length, typically around 5-6 feet. Using the glue
applicator, run the PVC glue around the last inch of pipe on one side,
as well as the inside of the end cap. Immediately put the end cap on
the pipe and work it down as far as you can. Next you can add
whatever type of filler that you want. I typically use sand, but you
can also use pea gravel, rocks, or a combination of whatever you
want. You might want to use a cheap plastic funnel for this if you're
pouring it out of a bag. Once it's filled, glue the other end cap and
tighten it onto the bar. That's all there is too it. Let me know if
you have further questions and good luck!
|
